| What We Race |
|
American Marblehead - Developmental Also called "M" or "50/800". The Marblehead is a medium-sized yacht providing exciting performance and the ability to handle most sailing conditions if rigged properly. This development class is restricted in overall length and sail area. The Marblehead was considered the leader in the use of advanced construction materials and techniques. 50" long, 800 sq. inches sail area.
The M or Marblehead Class, sometimes called the "50/800", is a medium size high performance development class. It's original concept in the 1930's was to produce the largest model that would conveniently fit in the standard American car of the time. The class is a development class with the main restrictions being a hull length of 50 inches and a sail area of 800 square inches. The class has been highly developed over the years to produce a high performance model that can be sailed in a wide range of conditions, assuming the owner has the appropriate rigs. Today's M weighs around ten pounds and carries an 85 inch rig in most conditions. The hull and rigs tend to use advanced materials and techniques. Boats are available from several suppliers who can provide them from basic kit form to fully assembled. There is also an active used boat market at the local level. The M Class has a large base, with over four hundred competitive models in existence. It is sailed in most areas of the country. Competition is available from club level to national level, and even international level. As an international class with the same rule as the rest of the world (except the measurements for AMYA are in inches and pounds), AMYA members can attend regattas abroad. They can also take advantage of several excellent foreign suppliers. When you are looking for a class to enter, look at the M Class. It has much to offer. | ||||||||
|
Footy - Developmental Sanctioned in 2006. Low cost, fun, easy to build class that puts to rest the theory that boats under 30" long don't sail well.
12" long (thus "Footy") is the smallest of the development class yachts.
That photo isn't skewed, this boat is called a Footy and it's ...yup 12 inches long. Sanctioned in 2006. Low cost, fun, easy to build class that puts to rest the theory that boats under 30" long don't sail well. 12" long (thus "Footy") is the smallest of the development class yachts. Class Website | ||||||||
|
Soling 1 Meter - One Design Sanctioned in 1993. The Soling 1 Meter is based on the full-size Olympic Soling.
Specifications: 39.37" long, 8-5/8" beam, approx. 60" bottom keel to tip of mast. 10 lbs. min.
Features: Performance; Single rig allowed means lower total cost; One Design for equality of boats; Kit-Based, kits Available from two manufacturers; Wide distribution of local clubs in all AMYA Regions. The Soling 1 Meter Class was first sanctioned by the AMYA in 1993. With thousands of kits sold, and some 4000 boats registered, you can find a Club sailing the Soling 1 Meter in ALL 8 AMYA Regions, and three Provinces in Canada. Over 70 USA and Canadian Clubs list the Soling 1 Meter as the one or the only boat that they support. Something like 50% of ALL RC sailors own at least one Soling!! For over thirty years since being AMYA-sanctioned, the "Soling" has been a Class that offered top competition at the local, Regional, and USA as well as Canadian National Championship levels.
Class RulesThe Soling 1 Meter is a true One-Design: All aspects related to performance are intended to be restricted to what can be achieved by building a Kit straight from the manufacturer's instructions. (The Soling 1 Meter Class Rules may be downloaded from the links table on this page.) Performance: Soling 1 Meters point high, sail fast, and resist "submarining" like some other more narrow and lighter boats. On a fresh reach or run, the boat gives her skipper fully controlled, exhilarating performance. The fin keel draws only about 8" of water, so the Soling 1 Meter is easier to carry and transport, and can be launched from a shore without wading, as well as from a dock. And, the Soling resists snagging in pond weeds - she can almost always be sailed back to shore, instead of having to be rescued by rowboat. Low total cost: Unlike many RC boats, Soling 1 Meter Class allows one rig, using lower cost flat-paneled polyester sails. The Soling can be sailed in winds from near zero to over 20 MPH, using that single rig. And, in a regatta of less than 5 days' duration, you must use the same rig throughout the regatta. This saves hundreds of dollars for additional rigs and sails required to be bought in order to compete in most other popular designs. Soling 1 Meters must be built from a kit available from the original manufacturer- Victor Model Products (out of business as of 2018), AND currently only from one of two Class-approved manufacturers: 3DRC Boats offers Almost ready to Sail kits that can be finished in about 12 hours by virtually anyone. 3DRC also sells full rig kits, aluminum mast and booms, with or without major brand sails. Vac-U- Boats offers an unassembled hull kit. You cannot modify the interior construction of the 3DRC or Vac-U-Boat kits, such as removing structure, or adding carbon fiber or other "exotic" materials. Made in the USA: All Solings, since the first off the mold, have been made in the USA. To buy a NEW Soling, contact one or both of our manufacturers: 3RC Boats TM sales@3drcboats.com Doug Rieger 1-440-610-9542 http://3drcboats.com OR Vac-U-BoatTM philpace@vac-u-boat.com Phil Pace 1259 Humphries Rd. Conyers, GA 30012 http://www.vac-u-boat.com/ | ||||||||