What We Race
DragonFlite 95 - One Design
More Information about this Class
The DragonFlite 95 is a Restricted One Design boat that is meant to compete within a strict set of rules to ensure a true test of a skipper's ability to tune their boat and race it well. Additionally, this 950mm boat is of high quality for a modest price. The DF95 is sold ready to race which includes transmitter and receiver, just add AA batteries. For those already in the hobby, a boat without transmitter and receiver can be purchased. The DF95 comes with a carbon fiber keel, Mylar sails, and a one piece carbon mast, all cutting edge components. It can be on the water in a few hours and assembled by a person with no experience building boats.
DragonForce 65 - One Design
More Information about this Class
The DragonForce 65 is the fastest growing class of RC sailboats in the U.S. The boat has earned this distinction by being a great one-design sailing boat while being the least expensive ready-to-sail boat on the market. At around $300 for a boat with radio and receiver and about 2 hours of assembly and you're on the water.

The boat has fleets at nearly 150 clubs around the country. The clubs range from well-established AMYA clubs, full sized boat yacht clubs, school sailing teams to community association clubs. Within these clubs the boat is sailed from beginners to national champion skippers from many other classes.

An added benefit of the boat is the well-supplied and dedicated national distributor that provides excellent access to boats, parts and accessories allowed by the class rules.
Micro Magic - One Design
More Information about this Class

The Micro Magic Class is one of the largest in the world, with affiliated fleets in over a dozen countries spread over four continents. Micro Magic kits were previously manufactured by Graupner of Germany and since 2020 by Hacker Model Production of the Czech Republic. Their design and basic look are patterned after single-handed trans-Atlantic boats popular in Europe called Mini 6.5's. The boat features an ABS hull and deck, carbon fiber spars and high-quality rigging hardware. The standard kit can be assembled with common adhesives and epoxies by builders with novice skills. And pre-assembled ARTR (almost ready to race) boats and good used boats are readily available. The class sails under the well-established International Micro Magic Rules, and is governed in the United States by the Micro Magic Class Owners Association.

Micro Magic class yachts can be sailed in a wide variety of wind conditions--from drifters to 30 knot winds utilizing smaller alternate sail rigs which are legal under the class rules. (The picture below shows Micro Magics sailing in strong wind with small rigs.) Their small size (21") and light weight (860 grams minimum) make Micro Magics extremely easy to transport and sail. Despite their size, they are very fast and sail as well as, if not better than, many larger radio-controlled sailboats.

Newport 12 Meter - One Design
More Information about this Class

The Newport 12 Meter is also referred to as the "West Coast 12 Meter". The hull is modeled after a full size 12 meter, arguably the most competitive class to ever compete for the America's cup. The Newport 12 is a large boat, 72" in length and 40 lbs. in weight, that rewards its skipper with a "real boat" feel while sailing. It is a one design boat whose class and rules are organized to provide a consistently competitive fleet that puts and emphasis on sailing skill.

Santa Barbara - One Design
More Information about this Class

If you have been looking for a radio controlled model yacht that majestically sails and elegantly maneuvers like a crew driven Maxi or 60 footer, the Santa Barbara One-Design (OD) is for you. The Santa Barbara is a fractional rigged sloop on a 70 inch long hull. It's designed for racing in a range of sailing conditions from performing well in light winds to being, well behaved and manageable in rough waters and 15 knots of wind. It was introduced in 1964 and was one of the first classes to be accepted by the newly formed AMYA in 1971. It is recognized as a modern classic throughout the association. Because of the one-design concept the boats built in the 1960's are competitive to those boats built in the 90's when racing around the buoys. Because of the history of stability in design the Santa Barbara remains popular in the association as a "class boat". The portability of the Santa Barbara is enhanced due to the removable mast, rudder and keel. Most sedans or coupes can transport your yacht to the nearest pond for a day of sailing.

Soling 1 Meter - One Design
More Information about this Class
The Soling 1 Meter Class was first sanctioned by the AMYA in 1993. With thousands of kits sold, and some 4000 boats registered, you can find a Club sailing the Soling 1 Meter in ALL 8 AMYA Regions, and three Provinces in Canada. Over 70 USA and Canadian Clubs list the Soling 1 Meter as the one or the only boat that they support. Something like 50% of ALL RC sailors own at least one Soling!! For over thirty years since being AMYA-sanctioned, the "Soling" has been a Class that offered top competition at the local, Regional, and USA as well as Canadian National Championship levels.
The Soling 1 Meter is a true One-Design: All aspects related to performance are intended to be restricted to what can be achieved by building a Kit straight from the manufacturer's instructions. (The Soling 1 Meter Class Rules may be downloaded from the links table on this page.)
Performance: Soling 1 Meters point high, sail fast, and resist "submarining" like some other more narrow and lighter boats. On a fresh reach or run, the boat gives her skipper fully controlled, exhilarating performance. The fin keel draws only about 8" of water, so the Soling 1 Meter is easier to carry and transport, and can be launched from a shore without wading, as well as from a dock. And, the Soling resists snagging in pond weeds - she can almost always be sailed back to shore, instead of having to be rescued by rowboat.
Low total cost: Unlike many RC boats, Soling 1 Meter Class allows one rig, using lower cost flat-paneled polyester sails. The Soling can be sailed in winds from near zero to over 20 MPH, using that single rig. And, in a regatta of less than 5 days' duration, you must use the same rig throughout the regatta. This saves hundreds of dollars for additional rigs and sails required to be bought in order to compete in most other popular designs.
Soling 1 Meters must be built from a kit available from the original manufacturer- Victor Model Products (out of business as of 2018), AND currently only from one of two Class-approved manufacturers:
3DRC Boats offers Almost ready to Sail kits that can be finished in about 12 hours by virtually anyone. 3DRC also sells full rig kits, aluminum mast and booms, with or without major brand sails.
Vac-U- Boats offers an unassembled hull kit.

You cannot modify the interior construction of the 3DRC or Vac-U-Boat kits, such as removing structure, or adding carbon fiber or other "exotic" materials.
Made in the USA: All Solings, since the first off the mold, have been made in the USA.
To buy a NEW Soling, contact one or both of our manufacturers:
3RC Boats TM
sales@3drcboats.com
Doug Rieger
1-440-610-9542
http://3drcboats.com
OR
Vac-U-BoatTM
philpace@vac-u-boat.com
Phil Pace
1259 Humphries Rd. Conyers, GA 30012
http://www.vac-u-boat.com/

Soling 50 M - One Design
More Information about this Class

The Soling 50 Class is a small-scale version (50 inches long) of the Olympic Soling three-person, 27 foot, 3 man, keelboat, sailed worldwide and also in the Olympic games since 1967. The original boat was designed by Jan Herman Linge of Oslo, Norway in 1964. The name "Soling" was a word coined by Linge.

In 1970, John & Laurie Converse, owners of Vortex Model Engineering saw a full sized Soling and developed and manufactured the radio-controlled model sailboat. It started out as the Soling M Class (Marblehead) and in 1972 it dominated the Marblehead Class ACCR 50/800 class. By 1975 the fleet grew into it's own class, called the Soling O/D (One Design) and it's logo the Greek letter 'Omega' was authorized by the original designer Jan Linge.

Today, the Soling 50 is one of 27 different classes and sizes of sailboats sanctioned by the national American Model Yacht Association and has very active fleets racing in California, Florida, Michigan and Texas and has individual boats scattered all over the U.S. The Soling 50 hulls are identical to the original Vortex hulls and are currently available from three (3) different suppliers in the U.S.

The Soling 50 Class is an AMYA one-design class boat. It is a great starter boat, easily transported with detachable sail rig weighing a minimum of 17 lbs. Radio equipment is an inexpensive 2 or 3 channel surface radio. The Soling 50 Class offers close and competitive sailing in moderate and stiff winds. It acts and feels closer to a full-sized boat than most other R/C model yachts.

US One Meter - Developmental
More Information about this Class
The One Meter yacht is lightweight, very fast and responsive to the controls making it a fun boat to sail, either as a pond boat or in competition.

An inexpensive two channel radio is all that is required for control of sails and rudder. The boat is easily disassembled and fits in a small size automobile for transporting to the pond or lake. The U.S. One Meter class is one of the least expensive classes for the new skipper just starting in the hobby of R.C. sailing due to its "build it yourself" nature, .

The U.S. One Meter Class is a developmental class, which means there are very few design restrictions. They include, overall hull length, keel depth and sail area (see class specification for the few remaining restrictions). The generally unrestrictive nature of the specifications, encourages one of a kind Home Built yachts. The hull can be self designed or built from available free plans. It is easily planked from wood, or can be made from wood forms covered with fiberglass, carbon fiber or Kevlar. The structure of the class specifications allows the designer/builder to experiment with a design, and then try it out on the water. It is a true "designers class".